ceramictoilet3dscanningmeasurementsolution

Ceramic toilet 3D scanning measurement solution

The 3D scanner obtains the complete 3D data of the ceramic sanitary ware-toilet and imports it into the design software. The designer can modify and create new works at will. With the 3D data of ceramic sanitary ware, industrialized mass production can also be carried out, which greatly reduces labor costs.

Client needs

1. Scan out all the data of the toilet and use it for reverse modeling. To obtain the complete 3D data of the toilet

2. Measure the maximum length, width and height of the toilet.

Ceramic toilet three-dimensional scanning reverse solution

1. Preparation

Marking points need to be affixed before scanning the toilet. It takes about 2 minutes to paste the marking points.

2. 3D scan the toilet to obtain the 3D data of the toilet

3. Measure the maximum length, width and height of the toilet

The origin position is shown in the figure

Cut the line at the widest place in the width direction to get the width: 425.2mm

Cut the line at the longest part of the length to get the length: 702.3mm

Cut the line at the highest height direction to get two heights: height 1 (the height from the top surface to the foot): 383.4mm, height 2 (the height from the top surface to the bottom surface): 365.3mm

Conclusion

The technical engineers of Jingyixun use a camera-type 3D scanner (PTS series) to quickly obtain the 3D data of the toilet, and then use Imageware software to fine-tune the point cloud file of the toilet in three XYZ directions, and find the exact center of the three directions as The coordinate origin is used to measure the size of the toilet. Our technical engineers quickly measured the maximum length, width and height of the toilet in the 3D software, which quickly met the needs of customers.